MP-101 Remote Controlled Motorized Camera Pan and Tilt Head.

The combination of the remote's speed control and the added diodes slowed the pan function to the desired level. Shop Bescor Battery Belts, Camera Batteries & Camera Lights at Markertek. BESCOR RE-20 Extension Cord, for MP-101 PAN Head Remote Control, 20FT. By itself this wasn't as slow as desired but it was found that the auto feature still is slowed by the speed control on the remote if you leave the remote plugged in. Bescor AC Power Supply for MP-101 Motorized Pan Head. This only caused panning 340 degrees to take 53 seconds instead of 43 seconds. Bescor MP-101 Overview 1Description 2Bescor MP-101 Motorized Pan & Tilt Head 3Bescor RE-20 20 Extension Cord - for MP-101 Pan Head Remote Control 4Bescor D-Tap Male to 2. The approached that worked was to install two diodes parallel to each other with opposing polarities to cause a consistent voltage drop of approximately one volt. The dual-motor design allows independent smooth remote adjustment of vertical and horizontal panning motion. The low value resistors I had on hand when tried just caused the motor to stop functioning. Bescor MP-101 Motorized Pan Head This motorized pan head fastens between any tripod head and video camera. This allowed me to swap out different value resistors and diodes without having to take the housing apart. I soldered two extension wires that I routed outside of the housing by drilling a small divot into the side. This was convent as all of the wire colors are used more than once except for the blue wire going to the pan motor. See below for more information on the individual items in. Included in this kit is a Bescor MP-101 motorized head which will pan/tilt cameras weighing up to 6 pounds, an AC adapter to provide power to the MP-101 head, and a 20 extension cable for the remote control included with the MP-101 head. PS-260 AC Power Supply for MP-101 Motorized Pan Head The Bescor PS-260 AC Power Supply for MP-101 Motorized Pan Head features a 120-240VAC, 60/50Hz input and 6VDC, 700mA output. With the Becsor MP-1E Kit you can remotely control your cameras pan/tilt from across the room. The simplest approach we could see to limit the speed of the pan function was to wire an impedance directly into the wires for the motor. The Bescor RE-50 extension affords 50' (15.24 m) of additional separation from the MP-101 remote pan head to its remote control.

Bescor mp-101 rear